施工工程圍擋的定義就是將建設施工現場與外部環境隔離，使施工現場成為比較封閉的空間的措施，包括用各種塊狀材料構筑的圍墻、由各種成形板材構成的維護體等。工程圍擋分為四種，相關特點要求你都清楚嗎？下面工程圍擋廠家講解下：

Construction engineering enclosure is defined as a measure to isolate the construction site from the external environment and make the construction site a relatively closed space, including a wall constructed of various block materials, a maintenance body composed of various shaped plates, etc. There are four types of engineering enclosures. Are you clear about the relevant characteristics and requirements? The following works are explained by the enclosure manufacturer:

一、砌筑式工程圍擋

1、 Masonry engineering enclosure

1.房屋建筑工程、建(構)筑物拆除工程、待建(儲備)地，以及圍擋使用周期1年以上，處于非城市道路且場地相對固定的市政工程應設置砌筑式圍擋。

1. Building construction works, building (structure) demolition works, land to be built (reserved), and municipal works with a service life of more than 1 year, which are located on non-urban roads and the site is relatively fixed, should be provided with masonry enclosures.

2.砌筑式圍擋應采用加氣混凝土砌塊、粉煤灰磚及非蒸壓灰砂磚等新型砌筑材料砌筑。

2. The masonry enclosure shall be constructed with new masonry materials such as aerated concrete block, fly ash brick and non-autoclaved lime sand brick.

3.砌筑式圍擋高度為2.5m，厚度不小于240mm，扶壁柱宜間隔不大于4.5m等距設置。

3. The height of masonry enclosure is 2.5m and the thickness is not less than 240mm. The buttress columns should be set at equal intervals of not more than 4.5m.

二、裝配式工程圍擋

2、 Fabricated engineering enclosure

1.圍擋使用周期1年以內的市政工程、園林景觀工程等，應設置裝配式圍擋。

1. For municipal engineering and landscape engineering with a service life of less than 1 year, prefabricated enclosure shall be set.

2.裝配式圍擋應采用輕鋼結構框架，面板采用雙層壓型鋼板、夾心板、彩色涂層鋼板、聚碳酸醋板或其他高度度的板材，圍擋結構應穩定。

2. The fabricated enclosure shall adopt light steel structure frame, and the panel shall adopt double-layer profiled steel plate, sandwich plate, color-coated steel plate, polycarbonate plate or other high degree plates. The enclosure structure shall be safe and stable.

3.裝配式圍擋高度為2.5m，間隔3m等距設置立柱,立柱應采用不小于3mm厚鍍鋅鋼管。

3. The height of the fabricated enclosure is 2.5m, and the columns are set at equal intervals of 3m. The columns shall be galvanized steel pipes with a thickness of not less than 3mm.

4.施工圍擋應設置300～500mm高基座，圍擋基座應平整順直，基面應找平處理。

4. The construction enclosure shall be provided with a 300~500mm high base. The enclosure base shall be flat and straight, and the base surface shall be leveled.

三、移動式工程圍擋

3、 Mobile engineering enclosure

1.圍擋使用周期30天內的工程，應設置移動式圍擋。

1. Movable enclosure shall be set for works with enclosure service life of 30 days.

2.移動式圍擋可根據項目類型和使用周期，選擇簡易夾心彩鋼板圍擋、水馬、簡易鐵馬及折疊布藝圍擋等形式。

2. According to the type and service life of the project, the mobile enclosure can be in the form of simple sandwich color steel enclosure, water horse, simple iron horse and folding fabric enclosure.

3.簡易夾心彩鋼板圍擋高度為2m，圍擋面板為擠塑板和0.3mm厚以上彩鋼板的復合板，支撐骨架采用鍍鋅角鋼;支架與地面之間采用螺栓錨固或采用沙袋對支架進行重壓固定。

3. The height of the simple sandwich color steel plate enclosure is 2m, the enclosure panel is a composite plate of extruded plate and color steel plate with a thickness of more than 0.3mm, and the support framework is galvanized angle steel; The support and the ground shall be anchored by bolts or fixed by sandbags.

四、特殊工程圍擋

4、 Special engineering enclosure

1.特殊圍擋是指高度超過3m，刊載戶外廣告等的大型鋼結構圍擋。

1. Special enclosure refers to a large steel structure enclosure with a height of more than 3m and outdoor advertisements.

2.設置特殊圍擋應符合城市戶外廣告管理的相關規定，并保證。

2. The setting of special enclosure shall comply with the relevant regulations of urban outdoor advertising management and ensure safety.

四種類型的工程圍擋有怎樣的特點要求？以上就是問題的相關解答內容了，希望能夠給您好的幫助，更多事項就來我們網站http://www.cdcwnj.com進行咨詢！

What are the characteristics and requirements of the four types of engineering enclosures? The above is the relevant answer to the question. I hope it can help you. Please come to our website for more matters http://www.cdcwnj.com Consult!